Cylindrical bore type for 1.25 in. / 31.75 mm. shaft diametr, outer ring surface is spherical, inner ring extented on both sides with set screw locking.
Made of stainless steel, greater chemical and corrosion resistance.
Have a lower load carrying capacity than same-sized bearings made of carbon chromium bearing steel.
Principal dimensions is 1.250х2.835х1.689 in. equal to 31.75х72х42.9 mm.
The inner ring is located on the shaft by two cup point hexagonal set screws offset by 120°, suitable for bearing arrangements with a constant direction of rotation or, under low speed and load, for an alternating direction of rotation.
Without coating.
Without relubrication feature, have no lubrication holes.
Capped on both sides by contact seal and an additional flinger with a vulcanized food-compatible NBR axial lips. The seal is made of a stainless sheet steel insert, with an NBR radial lip and concentric NBR gutters vulcanized to the seal's outer surface. The flinger is made of stainless steel, with an NBR axial lip and concentric NBR gutters vulcanized to the flinger's inner surface. Greased with the appropriate amount of high quality food-grade grease GFM, registered by NSF as category H1, under clean conditions. Recommended for applications with heavy detergent contamination and the highest food safety requirements.
Relubrication can extend bearing service life if the bearing have lubrication holes.
Polymer cage.
Inch series product.

Radial insert ball bearings are based on sealed deep groove ball bearings, this is ready-to-fit machine elements. They are highly suitable where predominantly radial loads must be supported. These bearings also give quieter running and lower vibration levels than standard radial insert ball bearings.

Picture for illustration purposes only, product may differ from image. See technical specification for details.